>https://twitter.com/JackPosobiec/status/1502430929859584004
>
To ake concentrate like Shatter they use a special tube and force Butane Fluid through it to pull the trichromes off then they dry.
How to Make Shatter
Material
High-quality material produces high-quality outputs. While there are parameter tweaks and “tricks” an operator may use to increase output quality, the old adage “fire in, fire out” rings true to this day. When making shatter and most other concentrates produced for vaporizing, we want to utilize the least amount of post-processing possible, in order to maintain the general composition of active ingredients from the raw input to the finished output.
The single largest consideration in creating the stable, glass-like shatter consistency is the moisture content of the input material. The material should be 8% water content or lower. Dry material makes achieving our goal consistency easier and repeatable. It’s also important to note that different cannabinoid and terpene profiles will alter the final form of the finished product.
Extraction
Standard low temperature hydrocarbon extraction parameters are utilized for primary extraction. Using low temperature extraction, as opposed to a higher temperature boiling solvent like ethanol, mitigates the extraction of phospholipids, thus creating a higher-quality, higher-potency finished product. Most operators will opt for a butane-dominant solvent blend or utilize 100% n-butane in this scenario. Too much propane will pull the lighter terpenes, thus increasing terpene content and influencing nucleation of THCa throughout the batch, causing it to “sugar.”
https://precisionextraction.com/2020/07/how-to-make-shatter/
>You're thinking of Bob Crane
add a little Bob Uecker to a little Bob Crane and you get
Bob Ukraine A pervert Pedo President
>You're thinking of Bob Crane
add a little Bob Uecker to a little Bob Crane and you get
Bob Ukraine A pervert Pedo Presdient